HydroPoint WeaterTRAK ET plus - Reviewing

Now change the destination station (Turn the Lower Line knob
“To STA 04.”)
Now press the Copy button.
The display will change briefly to this:
Then the display will change back to this:
Another example of the COPY function is:
This will copy program data from Station 1 to all stations of the
controller.
Note: If you want to make minor changes to the copied data,
simply turn the Function Selector knob to PROGRAM, set the
station number, and edit as needed.
COPY FROM STA 01
To ALL STA's (Press COPY)
COPY FROM STA 03
To STA 04 (Press COPY)
COPYING DONE!
COPY FROM STA 03
To STA 04 (Press COPY)
Programming Your WeatherTRAK ET plus 51