Troubleshoot Common Problems
102 811470 Operator Manual Powermax45 SYNC
None
Flashes
one after
the other
On
Yellow
The plasma power supply
was receiving a signal to
start cutting at the same
time that the power switch
was set to ON (I).
This fault code stops the system from operating.
Do the following.
• The torch trigger was being held in the “fire”
position when the power switch on the
plasma power supply was set to ON (I).
Release the trigger and do a quick restart of
the plasma power supply. Refer to page 90.
None
On
Flashes
Yellow
An AC input voltage phase
loss occurred.
This is applicable only to
3-phase models.
This fault code stops the system from operating.
• Have an electrical technician examine all
input phases and fuses/breakers for correct
voltage at the power source and at the
plasma power supply.
• If applicable, disconnect the system from
generator power.
• Do a cold restart. Refer to page 90.
Fault
code
Fault
LEDs
Torch
LEDs Description Solutions
To Next Page
Loading...
