Hypertherm Powermax45 SYNC - About the Hand Torch

Cut and Mark with the Hand Torch
4
64 811470 Operator Manual Powermax45 SYNC
About the hand torch
SmartSYNC hand torches come in 75° and 15°
models.
 The 75° hand torch is a general purpose torch
designed for the widest range of applications.
 The 15° hand torch is designed to point heat
away from the operator during gouging. It also
makes it easier to cut overhead or in areas that are not easy to reach.
SmartSYNC hand torch features include:
 A control on the torch that lets you adjust the output current (A) from the torch (refer to
page 58)
 Automatic setting of operating mode, amperage, and gas pressure related to the
Hypertherm cartridge that you install, the torch type, and the torch lead length
 Communication of cartridge information to the plasma power supply, such as cartridge type
 A torch-lock switch that prevents the torch from firing accidentally, even when the plasma
power supply is ON (Refer to Step 6 – Unlock the SmartSYNC torch on page 52.)
 The FastConnect quick-disconnect system that lets you easily remove and change torches
For information about the thicknesses you can cut and pierce with a SmartSYNC hand torch, refer
to Cutting specifications on page 25.