Operate the Plasma System
Powermax45 SYNC Operator Manual 811470 51
Step 5 – Set the power switch to ON (I)
Set the power switch to ON (I). The
switch is on the front panel of the
plasma power supply.
If the torch-lock switch is set
to the green “ready to
fire” ( ) position when you
set the power switch to ON,
the hand torch puts out a
puff of air. Refer to Warning
puffs of air on page 52.
If the torch-lock switch is set
to the yellow lock (X)
position when you set the
power switch to ON, the
Torch Cap LED on the front
panel comes on.
200 V – 240 V
400 V, 480 V
To Next Page
Loading...
