Hypertherm Powermax45 SYNC - Change a Cartridge; LED Behavior During a Cartridge Change

Operate the Plasma System
3
Powermax45 SYNC Operator Manual 811470 53
Change a cartridge
1. Move the torch-lock switch to the yellow
lock (X) position.
2. Remove the cartridge and install a new one.
Refer to Install the cartridge on page 50.
3. Move the torch-lock switch to the green “ready
to fire” ( ) position.
4. Pull the torch trigger 1 time to get the warning
puffs of air.
LED behavior during a cartridge change
On the plasma power supply:
1 2 3
Yellow Yellow
Green
When you set the torch-lock switch to the yellow lock (X) position while the plasma power supply is
ON, the Torch Cap light-emitting diode (LED) on the front panel illuminates and a 0-50-2 code
displays.
After you install the cartridge and set the torch-lock switch to the green “ready to fire” ( )
position, the Torch Cap LED extinguishes.
Hand torch: After the torch puts out the warning puffs of air, the 0-50-2 code extinguishes.
1
2
3