Hypertherm Powermax45 SYNC - Prepare the Power Cord and Plug; CSA Systems; CE;CCC Systems

Install and Set Up the Plasma Power Supply
2
Powermax45 SYNC Operator Manual 811470 35
Prepare the power cord and plug
CSA systems
* An approved plug must be installed on the power cord by a licensed electrician according to all national and
local codes.
CE/CCC systems
* An approved plug must be installed on the power cord by a licensed electrician according to all national and
local codes.
** Style H07RN-F cord is a harmonized, heavy-duty, flexible, rubber-insulated, black-neoprene-jacketed
multi-conductor IEC60245-4 / EN50525 European power cord with CE printed on the cord. The H07RN-F
cord used by Hypertherm also has a CCC certification to GB/T 5013.4, with CCC printed on the cord.
Model Configurations Power cord Power plug
1-phase
200 V – 240 V 10 AWG 3-wire
50 A, 250 V power plug
(NEMA 6-50P) included
3-phase
480 V
14 AWG 4-wire Power plug not included*
Model Configurations Power cord Power plug
1-phase 200 V – 240 V
10 AWG 3-wire
Power plug not included*
6mm
2
3-wire style
H07RN-F**
3-phase 380 / 400 V
2.5 mm
2
4-wire
styleH07RN-F**
Power plug not included*