Hypertherm Powermax45 SYNC - Put the Plasma Power Supply into the Correct Position

Install and Set Up the Plasma Power Supply
2
Powermax45 SYNC Operator Manual 811470 27
Put the plasma power supply into the correct position
 Do not use the system in rain or
snow.
 Put the plasma power supply
near the line-disconnect switch
or near an approved power
receptacle for your installation.
 Keep at least 0.25 m (10 inches)
of space around the plasma
power supply for sufficient
ventilation.
WARNING
CHANCE OF ELECTRIC SHOCK
Never cut under water or submerge the torch in water. Electric shock can cause serious
injury.
WARNING
TOXIC FUMES CAN CAUSE INJURY OR DEATH
Some metals, including stainless steel, can release toxic fumes when cut. Make sure that
your work site has sufficient ventilation to make sure that the air quality level meets all local
and national standards and regulations. Refer to the Safety and Compliance Manual
(80669C) for more information.
Clearance:
>0.25m (10inches)