Hypertherm Powermax45 SYNC - Select the Correct Cutting Cartridge

Cut and Mark with the Hand Torch
4
Powermax45 SYNC Operator Manual 811470 65
Select the correct cutting cartridge
Hypertherm offers the following types of hand-cutting cartridges, which can be used with both the
15° and the 75° SmartSYNC hand torches:
 For a full list of the cutting and gouging cartridges available, refer to the
Powermax45/65/85/105 SYNC Parts Guide (810490).
 If your preference is to keep a standoff while cutting, you can use the gray mechanized
cutting cartridges on your SmartSYNC hand torch.
 For information on gouging processes and cartridges, refer to Gouge with the Hand Torch
on page 77.

For help installing the cartridge, refer to Step 4 – Install the cartridge on
page 48.
Cartridge Type Purpose
Drag-cutting
(yellow)
Use these cartridges to drag the
torch on the workpiece (drag-cut)
for the widest range of cutting
applications.
FineCut
®
hand
(yellow)
Use these cartridges to get a
narrower kerf on thin mild steel
and stainless steel up to 3 mm
(10 gauge).
Also use this cartridge to mark
mild steel, stainless steel, and
aluminum. Refer to Mark with the
hand torch on page 72.