Operate the Plasma System
58 811470 Operator Manual Powermax45 SYNC
Adjust the output current manually
Make sure that the output current (A) you select is correct for your cutting or gouging application.
For example, an output current that is too low or too high for the material you are cutting may result
in poor cut quality.
1. Move the torch-lock switch to the green “ready to fire” ( ) position before you adjust the
output current.
2. Turn the adjustment knob as
necessary to set the output current
in increments of 1 A. You can also
use the hand torch to set the output
current. Refer to Adjust the output
current from the hand torch.
The mode LED flashes to let you
know that the amperage has
been manually adjusted. It
continues to flash until you reset
the current.
Adjust the output current from the hand torch
1. Push the button on the amperage adjustment control to move the current setting from one
preset amperage to another.
To Next Page
Loading...
