Hypertherm Powermax45 SYNC - Examine the Filter Element; Replace the Air Filter Bowl, O-Ring, and Filter Element

Complete Regular Maintenance Tasks
7
Powermax45 SYNC Operator Manual 811470 121
Examine the filter element
 Do a check of the filter element inside the air filter
bowl regularly, especially in environments that are
very dusty or very warm and humid.
 Replace the filter element when it is dirty or starts
to show signs of damage. Refer to the
Powermax45/65/85/105 SYNC Parts Guide
(810490).
Replace the air filter bowl, O-ring, and filter element
1. Twist the plastic fittings until they come apart, approximately a 1/4 turn. Set the fittings aside.
2. Put the new air filter element in the plastic fittings. Twist the
plastic fittings until they lock together, approximately a
1/4 turn.
3. Clean the air filter bowl by wiping away any oil, dirt, or other
contaminants.

A yellow residue on the filter bowl often indicates that oil
is getting into the gas supply line.
4. Discard the used O-ring , and put the new O-ring at the top of the filter bowl.
5. Put the filter element inside the air filter bowl. Push down on the top plastic fitting until you hear
a click.
Clean
1
11
2
2
3
3