Hypertherm Powermax45 SYNC - While Gas Test Mode Is Active

Troubleshoot Common Problems
6
11 0 811470 Operator Manual Powermax45 SYNC
4. The set pressure flashes on the 2-digit display before the actual output gas pressure
shows. Make note of the set pressure so that you can compare it to the actual pressure.

If the 2-digit display shows “0.0” (bar) or “00” (psi) when you enter gas
test mode, the torch is not in a “ready to fire” state. In this case, pull the
trigger. The system then emits the warning puffs of air (refer to page 52)
and displays the actual pressure.
While gas test mode is active
 Air flows continuously from the torch tip .
 The 2-digit display shows the output gas pressure .
 The AMPS LED remains off.
1
2
1
2
1
2
3
1
2
3