Hypertherm Powermax45 SYNC - Go Back to Automatic Settings Mode

Operate the Plasma System
3
60 811470 Operator Manual Powermax45 SYNC
Go back to automatic settings mode
To go back to automatic settings mode, push the Mode button . The selected mode LED next
to the button stops flashing.
 When you change from manual gas pressure mode to automatic gas pressure mode:
 The plasma power supply automatically sets the gas pressure related to the Hypertherm
cartridge.
 The amperage setting stays the same.
 When you change from automatic gas pressure mode to manual gas pressure mode:
 The plasma power supply uses the last manual gas pressure that you set.
 The amperage setting stays the same.
 When you do a quick restart or a cold restart of the plasma power supply in manual
gas pressure mode:
 The plasma power supply keeps the last manual gas pressure and amperage that you
set, unless you install a different type of cartridge.
 When you connect a different torch, the plasma power supply returns to automatic gas
pressure mode.
1
2
12