Powermax45 SYNC Operator Manual 811470 45
Operate the Plasma System
Step 1 – Make sure that the plasma power supply is connected to power and gas
1. Make sure that the plasma power supply’s power cord is correctly connected to electrical power
according to national and local codes. Refer to Connect to electrical power on page 30, and
Prepare the power cord and plug on page 35.
2. Connect the gas supply line to the fitting on the back of the plasma power supply. Refer to
page 37.
For gas supply requirements, refer to Inlet gas pressure requirements (while gas is flowing)
on page 40.
To Next Page
Loading...
