Hypertherm Powermax45 SYNC - Each Use

Complete Regular Maintenance Tasks
7
Powermax45 SYNC Operator Manual 811470 11 5
Each use
Plasma power supply Torch
Examine the indicator LEDs and correct any fault conditions.
Refer to Fault icons and fault codes on page 96.
Examine the cartridge for correct installation and
for wear. Refer to Signs that a cartridge is near
end-of-life on page 74 and Cartridge
maintenance on page 118.
To prevent overheating, do the following:
• Examine the work lead connector to make sure that it is
fully connected to the plasma power supply and is not
loose. Make sure that you turn the connector clockwise
approximately 1/4 turn until the connector is fully engaged
and locked in position.
• Do a check of the plug on the work lead. When a plug is
replaced, damage to the wire inside the plug can occur. If
the plug on the work lead has been replaced, look for
damage.
1
3
2