Hypertherm Powermax45 SYNC - Step 2 - Connect the Torch Lead

Operate the Plasma System
3
46 811470 Operator Manual Powermax45 SYNC
Step 2 – Connect the torch lead
 Always set the power
switch on the plasma
power supply to OFF (O)
before you connect or
disconnect a torch.
 To connect a hand torch
or machine torch, push
the connector into the
receptacle on the front of
the plasma power supply.
The connector makes a
click when it is fully
engaged.
 To disconnect the torch,
push the red button on
the connector and pull
the connector out of the
receptacle.
1
1