Hypertherm Powermax45 SYNC - Install and Set up the Plasma Power Supply

Powermax45 SYNC Operator Manual 811470 17
Install and Set Up the Plasma Power Supply
The Powermax45 SYNC is a portable 45 A plasma cutting system that you can use for many
handheld and mechanized cutting and gouging applications. The system’s automatic gas and
automatic voltage features make it easy to set up and use even if you have limited plasma cutting
experience.
With the Powermax45 SYNC you can:
 Use air or nitrogen to cut
electrically conductive metals
such as mild steel,
stainless steel, and aluminum.
 Use F5 gas to cut stainless steel.
 Use a single-piece cartridge
instead of a set of consumables.
 Let the plasma power supply
automatically set the operating
mode, output current (A), and
gas pressure related to the
SmartSYNC torch and
Hypertherm cartridge that you
install.
 Monitor cartridge life using the
Hypertherm Cartridge Reader kit (528083).
 Lock the SmartSYNC torches without setting the plasma power supply to OFF.
 Change between torches using the FastConnect™ system (quick-disconnect).