Troubleshoot Common Problems
108 811470 Operator Manual Powermax45 SYNC
0-98-2
ON
ON
Flashes
yellow
A communication failure
occurred between the torch
and the plasma power
supply.
This fault code does not stop the system from
operating.
When this fault occurs, the SmartSYNC torch is
not sending data to the plasma power supply.
The problem can be with the torch or with the
plasma power supply.
A qualified service technician must identify the
source of the fault and repair the component
that is damaged. Speak to your distributor or
authorized repair facility.
You can continue to cut or gouge, but you must
set the output current (A) and the operating
mode manually.
Fault
code
Fault
LEDs
Torch
LEDs Description Solutions
To Next Page
Loading...
