Install and Set Up the Plasma Power Supply
20 811470 Operator Manual Powermax45 SYNC
Input voltage (U1) / Input
current (I1) at rated output
(U2 MAX I2 MAX)
(Refer to Voltage configurations on
page 31.)
CSA (50 Hz/60Hz)
1-phase:
• 200 V: 40 A
• 208 V: 37.5 A
• 240 V: 33 A
3-phase
• 480 V: 10 A
CE/CCC (50 Hz/60 Hz)
1-phase
†
,
††
• 220 V: 37 A
• 230 V: 34.3 A
3-phase
†
,
†††
•380V: 13A
• 400 V: 12 A
Gas type Air Nitrogen (N
2
)F5
‡
Gas quality Clean, dry, oil-free per
ISO 8573-1
Class 1.2.2
99.95% pure
Clean, dry, oil-free
99.98% pure
(F5 = 95% nitrogen [N
2
], 5%
hydrogen [H])
Recommended gas inlet
flow rate/pressure
Cutting
188.8 L/min at 5.9 bar (400 scfh at
85 psi)
Maximum removal gouging
165.2 slpm (350 scfh) at a minimum 4.1
bar (60 psi)
* Defined as a plot of output voltage versus output current.
**
Refer to the data plate on the bottom of the plasma power supply for more information on duty cycle and for
IEC ratings.
*** NOTICE: This Class A equipment is not intended for use in residential locations where the public low voltage supply
system supplies the electrical power. It is not always easy to supply electromagnetic compatibility in those locations,
because of conducted as well as radiated disturbances.
†
This product meets the technical requirements of IEC 61000-3-3 and is not subject to conditional connection.
††
Equipment complies with IEC 61000-3-12.
†††
Equipment complies with IEC 61000-3-12 if the short-circuit power S
sc
is greater than or equal to 1003 KVA at the
interface point between the operator’s supply and the public system. The installer or user of the equipment must
consult with the distribution network operator, if necessary, to ensure that the equipment is connected only to a power
supply with a short-circuit power (Ssc) greater than or equal to 1003 KVA.
‡
F5 is only recommended to cut stainless steel.
To Next Page
Loading...
