Cut and Mark with the Hand Torch
Powermax45 SYNC Operator Manual 811470 67
To prevent accidental firing, the hand torch has a torch-lock switch and a safety trigger. To fire the
torch, do the following:
1. Install the correct cartridge. Refer to Step 4 – Install the cartridge on page 48.
When you install a Hypertherm cutting cartridge, the system goes to Cut mode .
When you install a cutting cartridge, Gouge mode is not available.
2. Make sure that the torch-lock switch is
in the green “ready to fire” ( ) position.
The first time that you pull the
torch trigger after you set the
torch to the “ready to fire”
position, multiple puffs of air
quickly come from the torch. This
is a warning that the torch is
active and will fire an arc the next
time that you pull the trigger.
Refer to Warning puffs of air on
page 52.
3. Flip the trigger’s safety cover forward
(toward the torch head) and pull the red
torch trigger.
After you complete a cut and
release the torch trigger, air
continues to flow from the torch
to decrease the temperature of
the cartridge. This is referred to
as postflow.
Always let postflow complete
before you remove a cartridge.
To Next Page
Loading...
