Hypertherm Powermax45 SYNC - Page 95

Troubleshoot Common Problems
6
Powermax45 SYNC Operator Manual 811470 95
The gouge has too much
width.
• Put the torch in a more upright position.
• Decrease the arc stretch (standoff).
• Increase the gouging speed.
• Decrease the output current (A). Refer to Guidelines for hand torch gouging on
page 82.
The gouge does not have
enough width.
• Tilt the torch down so that it is closer to the workpiece.
• Increase the arc stretch (standoff).
• Decrease the gouging speed.
• Increase output current (A). Refer to Guidelines for hand torch gouging on
page 82.
Problem Solution