EasyManuals Logo

IAI ROBO Cylinder RCS4- SA4C User Manual

Default Icon
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Safety Guide
Intro-6
No. Operation Precautions
6 Trial
Operation
When working with two or more persons, make it clear who is to be in charge
and communicate well with each other to ensure safety.
After teaching or programming, carry out trial operation step by step before
switching to automatic operation.
When trial operation is to be performed inside the safety/protection fence,
use the same work procedure, determined in advance, as teaching operation.
Be sure to confirm program operation at safe speeds. Otherwise, this may lead
to accidents due to unexpected motion caused by program error, etc.
Do not touch the terminal block or any of the various setting switches while the
equipment is live. Otherwise, this may lead to electric shock or abnormal
operation.
7 Automatic
Operation
Check before starting automatic operation or restarting after operation stop that
there is nobody within the safety/protection fence.
Before starting automatic operation, make sure that all peripheral equipment is
ready for automatic operation and that there is no alarm indication.
Be sure to start automatic operation from outside the safety/protection fence.
If the product produces abnormal heat, smoke, odor, or noise, immediately stop
it and turn OFF the power switch. Otherwise, this may lead to fire or damage to
the product.
When a power failure occurs, turn OFF the power switch. Otherwise, this may
lead to injury or product damage due to unexpected product motion during
recovery from the power failure.
8 Maintenance
and
Inspection
When working with two or more persons, make it clear who is to be in charge
and communicate well with each other to ensure safety.
Perform the work outside the safety/protection fence, if possible.
If operation must be performed within the safety/protection fence, prepare
"Work Regulations" and make sure that all the workers acknowledge and
understand them well.
When work is to be performed inside the safety/protection fence, turn OFF the
power switch as a rule.
When operation is to be performed inside the safety/protection fence,
operators should have emergency stop switches available at hand so that the
unit can be stopped at any time if abnormalities occur.
When operation is to be performed inside the safety/protection fence,
have a monitor standing by in addition to the operator(s) so that the unit can be
stopped at any time if abnormalities occur. Also, keep watch on the operation
so that a third party cannot operate the switches carelessly.
Place a sign indicating "Operating" where it can be seen easily.
For the grease for the guide or ball screw, use appropriate grease according to
the Instruction Manual for each model.
Do not perform dielectric strength testing. Otherwise, this may lead to damage
to the product.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IAI ROBO Cylinder RCS4- SA4C and is the answer not in the manual?

IAI ROBO Cylinder RCS4- SA4C Specifications

General IconGeneral
BrandIAI
ModelROBO Cylinder RCS4- SA4C
CategoryController
LanguageEnglish

Related product manuals