Precautions for Handling
International Standard Compliance
Intro-10
5. If return operations are continued over a short distance, they may rapidly
degrade the film of grease.
Continuous return operation within a distance less than 30mm may cause the grease film to
degrade rapidly.
As a guideline, in every 5,000 to 10,000 cycles, have approximately 5 cycles of return operation
over a 50mm distance or more to regenerate the oil film. Continued use of the actuator in that
state may lead to breakdown.
In extreme cases, flaking may occur on the guide or ball screw.
6. Do not attempt to have sliders collide with an obstacle at high speed.
This may damage the coupling or other mechanical parts.
7. For Double Slider Specification (Option Code: W) in Reversed-home
Specification (Option Code: NM), make sure to have the home-return
operation conducted after joining the driver slider and free slider.
8. In some conditions of environment of use, postures of installation and
conditions of operation, the base oil separated from the grease may come out
of ROBO Cylinder.
It is recommended to have a protection in case the peripheral devices could
get influence of the base oil.
International Standard Compliance
The ROBO Cylinder complies with the following overseas standards.
Refer to the Overseas Standard Compliance Manual (ME0287) for more detailed information.
CE Marking RoHS Directive
{ {
To Next Page
Loading...
Need help?
General
