4.3 Visual inspection items
4-4
4. Maintenance and Inspection
4.3 Visual inspection items
Refer to "4.6 How to replace components" for detailed information about specific component
replacement and adjustment methods.
External visual inspection
Inspection items Maintenance work
Is abnormal noise or vibration generated?
Take an action by referring to
“Troubleshooting in Controller Instruction
Manual”.
Are actuator mounting bolts loose? Tighten them further.
Is the cable scratched? Replace if the damage is severe.
Is the connector loose? Re-insert correctly.
Is grease dripping out?
(especially if vertically mounted)
Clean up any drips.
Replenish the grease.
Is the stainless steel sheet scratched? Replace the stainless steel sheet.
Is the stainless steel sheet misaligned or
slack?
Adjust the alignment and hang.
To Next Page
Loading...
