IBM 6400 Maintenance Information Manual

180
Chapter 6 Loading Flash Memory
ERROR: WRITING
TO FLASH
Hardware or software fault in flash
memory.
Download the program
again: Power off the
printer and start over at
step 12. If the message
occurs again, replace the
flash memory.
ERROR: WRONG
CHECKSUM
The printer received the complete
program but the checksum did not
match. The data were corrupted
during download.
Download the program
again: Power off the
printer and start over at
step 12.
ERROR OCCURRED
FLUSHING QUEUES*
An interim message that displays
while the printer discards host data it
cannot use because a fault condition
exists. While this message displays,
the asterisk (*) rotates.
Wait. When the asterisk
(*) stops rotating, a
different fault message
will appear: troubleshoot
the final message.
LOADING PROGRAM
FROM PORT XX%
The new program is loading into
printer RAM. XX indicates how much
of the program has loaded.
None
LOADING PROGRAM
INTO FLASH
The printer has deleted the previous
program from flash memory and is
loading the new program into flash
memory.
None
RESETTING . . .
PLEASE WAIT
The printer finished loading the
program into flash memory and is
automatically resetting itself.
None
RESTORING
BOOT CODE
Normal download initialization
message.
None
SECURITY CODE
VIOLATION
The software running or being
downloaded does not match the
security PAL code.
Install the correct PAL or
program. (PAL and
program must match.)
SENDING PROGRAM
TO EC PROCESSOR
The printer is loading the engine
controller program into the engine
controller.
None
TABLE MISMATCH
DOWNLOAD AGAIN
EC software update in process. Download the program
again: Power off the
printer and start over at
step 12.
Table 7. Flash Memory Message Guide
Message Explanation
Required
Action

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English