Table 2. Firmware Checkpoints. (continued)
Checkpoint Description Action/ Possible Failing FRU
E243 Setup configuration registers. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E244 Enable system speaker and send a
beep.
Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E246 System firmware corrupted, take
recovery path.
Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E247 Capture memory module SPDs into
NVRAM.
Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E249 Enter recover path’s main code. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E297 Start firmware softload path execution. See “Unresolved Checkpoint Problems”
on page 85.
E298 Start firmware recovery path execution. See “Unresolved Checkpoint Problems”
on page 85.
E299 Start C code execution. See “Unresolved Checkpoint Problems”
on page 85.
E3xx Memory test See “MAP 1240: Memory Problem
Resolution” on page 49.
E440 Validate NVRAM, initialize partitions as
needed.
1. Verify that the system and service
processor firmware levels are at the
current release levels; update as
necessary.
2. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E441 Generate /options node NVRAM
configuration variable properties.
1. Verify that the system and service
processor firmware levels are at the
current release levels; update as
necessary.
2. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E442 Validate NVRAM partitions. 1. Verify that the system and service
processor firmware levels are at the
current release levels; update as
necessary.
2. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
108 Service Guide
To Next Page
Loading...
