Table 3. Firmware Error Codes. (continued)
Error Code Description Action / Possible Failing FRU
4BA80014 NVRAM (CRC) checksum fail. This is a recoverable temporary
condition, unless followed by
4BA80015. If the system hangs at this
error code:
1. Remove, then reapply AC power.
The service processor settings
(modem speeds and call-out
numbers, for example) may have
to be reentered
2. Call service support.
4BA80015 NVRAM reintialization fail. 1. Remove, then reapply AC power.
The service processor settings
(modem speeds and call-out
numbers, for example) may have
to be reentered
2. Replace the system board.
Location: P1
(See note 3 on page 115.)
The service processor settings
(modem speeds and call-out
numbers, for example) will have to
be reentered.
Chapter 5. Error Code to FRU Index
175
To Next Page
Loading...
