IBM 6C1 - Page 263

Selecting the Data Rate option allows you the change the media employed by the
Ethernet adapter:
Select Data Rate
1. 10 Mbps
2. 100 Mbps
3. Auto
--------------------------------------------------------------------------------------------------
Navigator keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigator key: _
Selecting the Full Duplex option allows you to change how the Ethernet adapter
communicates with the network:
Select Full Duplex Mode
1. Yes
2. No
3. Auto
--------------------------------------------------------------------------------------------------
Navigator keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigator key: _
Select Ping, from the Network Parameters Menu, to test a connection to a remote
system unit. After selecting the Ping option, you must choose which adapter
communicates with the remote system.
Adapter Parameters
Device Slot Hardware Address
1. 100/10 Ethernet 5:P1-I5/E1 0060940d5151
2. fddi 4:P1-I4/Q1 00005a4263cd
3. 100/10 Ethernet Integrated: P1/E1 000000000000
--------------------------------------------------------------------------------------------------
Navigator keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigator key: _
Chapter 8. Using System Management Services 245