2. Install the power supply (1) in the bay:
a. Place the handle (5) on the power supply in the open position (that is,
perpendicular to the power supply) and slide the power supply into the chassis.
b. Gently close the handle to seat the power supply in the bay.
3. Plug the power cord for the added power supply into the power cord connector (4).
4. Route the power cord through the cable-restraint bracket (3) and the cable
management arm.
5. Plug the power cord into a properly grounded electrical outlet.
6. Verify that the dc power light (7) and ac power light (6) on the power supply are lit,
indicating that the power supply is operating correctly.
286 Service Guide
To Next Page
Loading...
