Chapter 21. Hardware and software upgrades 305
Figure 21-2 Boot loader
Next, run the autoboot command and perform another reboot if DOT 8 did not load
immediately after the flash update.
After the boot process is complete, verify the version by running the version and sysconfig
commands, as shown in Example 21-6.
Example 21-6 Version and sysconfig post upgrade
N6070A> version
Data ONTAP Release 8.1 7-Mode: Wed Apr 25 23:47:02 PDT 2012
N6070A> sysconfig
Data ONTAP Release 8.1 7-Mode: Wed Apr 25 23:47:02 PDT 2012
System ID: 0151696979 (N6070A); partner ID: 0151697146 (N6070B)
System Serial Number: 2858133001611 (N6070A)
System Rev: A1
System Storage Configuration: Multi-Path HA
System ACP Connectivity: NA
slot 0: System Board
Processors: 4
Processor type: Opteron
Memory Size: 16384 MB
Memory Attributes: Node Interleaving
Bank Interleaving
Hoisting
Chipkill ECC
Controller: A
Remote LAN Module Status: Online
To Next Page
Loading...
