Chapter 9. Management 469
Figure 9-18 IBM Systems Director login web page
2. After you log in to the console, navigate to Inventory ï‚® System Discovery in the left
navigation pane. In the right pane, select a discovery option in the Select a discovery
option pull-down list. IBM Systems Director defaults to discovering a single system using
IPv4 address resolution.
3. Enter the IP address of the IMM in the space that is provided under IP address.
4. An IMM is considered a server object in IBM Systems Director. To specify the IMM as a
Server object, click the Select the resource type to discover list box and select Server
as the resource type, as shown in Figure 9-19 on page 470.
5. Click Discover Now when you are ready to discover the IMM.
6. An informational message indicating that the discovery job has commenced appears at
the top of the right pane. Click Close Message to acknowledge the message.
7. The discovered IMM appears at the bottom of the System Discovery pane under
Discovered Manageable Systems. At this point, the IMM has been discovered but has not
been authenticated to. Notice the No Access status under the Access column. Before
authenticating to the IMM, we advise that you rename it first. The renaming process can
be performed at a later stage as well, but we advise that you perform this process at
discovery time, because it is easier to identify individually discovered IMMs for renaming
than when they are in a group.
To Next Page
Loading...
Need help?
General
