Chapter 2. IBM eX5 technology 35
Figure 2-14 Shows option for putting a partition into stand-alone mode
Figure 2-15 HX5 partition in stand-alone mode
The AMM can be accessed remotely, so partitioning can be done without physically touching
the systems. Partitioning can allow you to qualify two system types with little additional work,
and it allows you more flexibility in system types for better workload optimization.
The HX5 blade, when scaled as a 2-node (4-socket) system, supports FlexNode partitioning
as standard.
Before a 2-node HX5 solution can be used, you must create a partition. When the scalability
card is added, the two blades still act as single nodes until a partition is made.
For more information about creating a scalable complex, see 8.6, “Creating an HX5 scalable
complex” on page 402.
To Next Page
Loading...
Need help?
General