Icom IC-705 - Band Edge Beep; Entering a Band Edge; Selecting a Memory Channel by Number

3-5
BASIC MANUAL
3
BASIC OPERATION
Setting the frequency
D Directly entering a frequency (Continued)
Selecting a Memory channel by number
1. Select the Memory mode. (p. 3-1)
2. Select a memory group.
LTo select a memory group, touch the VFO/
MEMORY icon, and then touch [GROUP].
3. Touch the MHz digits. (Example: 14)
• Opens the BAND STACKING REGISTER
screen.
4. Touch [F-INP].
• Opens the F-INP screen.
5. Enter a Memory channel number. (Example: 2)
LIf the Call channel group is selected, enter
between “0” and “3.”
0: 144 C1
1: 144 C2
2: 430 C1
3: 430 C2
6. Touch [MEMO] to set the memory channel of
the entered number.
• Closes the F-INP screen.
• The selected memory channel contents are
displayed.
DBand Edge Beep
You will hear a Band Edge Beep and (with a
dotted line) will be displayed when you tune into
or out of an amateur band’s frequency range.
LYou can change the Band Edge Beep settings in
the following menu.
»
SET > Function > Band Edge Beep
LIf “Beep Level” is set to “0%,” no beep sounds.
»
SET > Function > Beep Level
DEntering a Band Edge
When “ON (User)” or “ON (User) & TX Limit” is
selected on the “Band Edge Beep” screen, you
can enter a total of 30 band edge frequency
pairs.
LInformation
• Initially, all Ham band frequencies are entered.
Therefore, you must first edit or delete them, and
then insert a new line to enter a new band edge.
• You cannot enter an overlapping frequency, or
a frequency that is out of the preset Ham band
frequencies.
• Band edges are entered from the lower frequency
first.
• These settings are easy with the CS-705. (p. 12-1)
1. Open the “Band Edge Beep” screen.
»
SET > Function > Band Edge Beep
2. Touch “ON (User)” or “ON (User) & TX Limit.”
LIf you set “ON (User) & TX Limit,” you can limit
transmission to within the entered frequency
range.
3. Touch “User Band Edge.”
• Opens the “User Band Edge” screen.