Icom IC-705 - Specifications

11-1
BASIC MANUAL
11
11
SPECIFICATIONS
DGeneral
• Frequency coverage (unit: MHz):
USA version
Receiver 0.030000 ~ 199.999999*
400.000000 ~ 470.000000*
Transmitter 1.800000 ~ 1.999999
3.500000 ~ 3.999999
5.255000 ~ 5.405000
7.000000 ~ 7.300000
10.100000 ~ 10.150000
14.000000 ~ 14.350000
18.068000 ~ 18.168000
21.000000 ~ 21.450000
24.890000 ~ 24.990000
28.000000 ~ 29.700000
50.000000 ~ 54.000000
144.000000 ~ 148.000000
430.000000 ~ 450.000000
EUR version
Receiver 0.030000 ~ 199.999999*
400.000000 ~ 470.000000*
Transmitter
1.810000 ~ 1.999999
3.500000 ~ 3.800000
7.000000 ~ 7.200000
10.100000 ~ 10.150000
14.000000 ~ 14.350000
18.068000 ~ 18.168000
21.000000 ~ 21.450000
24.890000 ~ 24.990000
28.000000 ~ 29.700000
50.000000 ~ 52.000000
144.000000 ~ 146.000000
430.000000 ~ 440.000000
* Some frequency ranges are not guaranteed.
• Operating modes:
USB/LSB (J3E), CW (A1A), RTTY (F1B), AM
(A3E), FM/WFM* (F2D/F3E), and DV (F7W)
* WFM: RX only
• Number of memory channels:
500 channels (in 100 groups)
• Number of program scan channels:
25 channels
(2 edge frequencies in each channel)
• Number of call channels:
4 channels (2 channels × 2 bands)
• Number of repeater memories: 2500
• Number of GPS memories: 300
• Antenna impedance: 50 Ω unbalanced
• Antenna connector: BNC (50 Ω)
• Power supply requirement:
13.8 V DC (±15%) for external DC power
7.4 V DC specified Icom’s battery pack
• Operating temperature range:
–10°C ~ +60°C, 14°F ~ 140°F
• Frequency stability:
Less than ±0.5 ppm
(–10°C ~ +60°C, 14°F ~ 140°F)
• Frequency resolution: 1 Hz (minimum)
• Power consumption:
Using external DC power (13.8 V DC)
Receive
Standby 0.3 A (typical)
Maximum audio 0.5 A (typical)
Transmit
Maximum power (10 W) 3.0 A
Using specified Icom’s battery pack (7.4 V DC)
Receive
Standby 0.5 A (typical)
Maximum audio 0.8 A (typical)
Transmit
Maximum power (5 W) 2.5 A
• Dimensions (projections not included):
200.0 (W) × 83.5 (H) × 82.0 (D) mm,
7.9 (W) × 3.3 (H) × 3.2 (D) in
• Weight (approximate): 1.1 kg, 2.4 Ib
DTransmitter
• Transmit output power:
Using external DC power (13.8 V DC)
SSB, CW, FM, RTTY, DV 0.1 ~ 10 W
AM 0.025 ~ 2.5 W
Using specified Icom’s battery pack (7.4 V DC)
SSB, CW, FM, RTTY, DV 0.1 ~ 5 W
AM 0.025 ~ 1.25 W
• SAR 10g: 0.643 W/kg
• Modulation system:
SSB Digital PSN modulation
FM Digital Reactance modulation
AM Digital Low power modulation
DV Digital GMSK modulation
• Spurious emission:
Harmonics
1.8 ~ 28 MHz band Less than –50 dB
50 MHz band Less than –60 dB
144/430 MHz band Less than –60 dB
Out-of-band emission
1.8 ~ 28 MHz band Less than –40 dB
50 MHz band Less than –60 dB
144/430 MHz band Less than –60 dB
• Carrier suppression: More than 50 dB
• Unwanted sideband suppression:
More than 50 dB
• Microphone impedance: 2.2 kΩ