8-20
BASIC MANUAL
SET MODE
8
8
»
SET > Bluetooth Set > Data Device Set
Serialport Function
(Default: CI-V (Echo Back OFF))
Sets the serial port function for the Bluetooth
SPP (Serial Port Profile) connection to a data
device, PC, and so on.
• CI-V (Echo Back OFF):
Transmits or receives a CI-V
command.
Does not send back the serial data
received from the SPP connection.
• CI-V (Echo Back ON):
Transmits or receives a CI-V
command.
Sends back the serial data received
from the SPP connection.
• DV Data: Transmits or receives data in the
DV mode.
Does not input the cloning or
weather data entries, or output the
GPS data.
»
SET > Bluetooth Set
Bluetooth Device Information
Displays the Bluetooth device information.
Initialize Bluetooth Device
Initializes the installed Bluetooth unit.
WLAN Set
»
SET > WLAN Set
WLAN (Default: OFF)
Turns the Wireless LAN function ON or OFF.
»
SET > WLAN Set > Connection Settings
Access Point
Displays the Access Point to connect.
LSee the Advanced Manual for details.
»
SET > WLAN Set > Connection Settings
> Manual Connect
SSID (Default: (blank))
Enter the SSID that is programmed in the
Access Point.
Security Type (Default: WPA/WPA2)
Sets the security type to connect to the Access
Point to None, WEP, or WPA/WPA2.
LSelect the same security type as the Access Point,
otherwise you cannot communicate with it.
Password (Default: (blank))
When “Security Type” is set to “WEP” or “WPA/
WPA2,” enters the WEP key or PSK key of the
Access Point.
<<Connect>>
After setting “SSID,” “Security Type,” and
“Password,” touch to connect to the Access
Point.
»
SET > WLAN Set > Connection Settings
DHCP (Valid after Restart) (Default: ON)
Turns the DHCP function ON or OFF.
• OFF: Uses a static IP address.
• ON: Uses the DHCP function.
If a DHCP server is in your network
environment, the IP address is
automatically obtained.
IP Address (Valid after Restart)
(Default: 192.168.0.10)
Sets the static IP address.
To Next Page
Loading...
