Icom IC-705 - Fast Data; GPS Data Speed; TX Delay (PTT); Digital Monitor

8-9
BASIC MANUAL
8
SET MODE
DV Set
»
SET > DV Set > DV Fast Data
Fast Data (Default: OFF)
Selects whether or not to use the DV Fast Data
function for data communication in the DV mode.
The DV Fast Data function uses the data and
the audio frames to send data approximately
3.5 times faster than the normal speed. So, no
audio can be sent.
• OFF: Sends data at a slow speed
(approximately 950 bps).
• ON: Sends data at a fast speed
(approximately 3480 bps).
LEven if “ON” is selected, when you push the
microphone’s [PTT], the data is sent at the slow
speed, because the audio frame is used for the
audio transmission.
The GPS data speed is set in “GPS Data Speed.”
GPS Data Speed (Default: Slow)
Sets the GPS data speed when the data is sent
using the DV Fast Data function.
• Slow: Sends GPS data in the slow speed
(approximately 950 bps).
• Fast: Sends GPS data in the fast speed
(approximately 3480 bps).
TX Delay (PTT) (Default: 2sec)
Sets the time for when the transceiver returns
to receive after sending DV data in the DV Fast
Data mode using the microphone’s [PTT].
• OFF: After releasing [PTT], the
transceiver returns to receive.
• 1 ~ 10sec: After releasing [PTT], the
transceiver sends data using the
DV Fast Data mode for this set
period.
When the TX data is completely
sent within this set period, the
transceiver automatically returns
to receive.
NOTE: This function is usable only when “DV
Data TX” is set to “PTT.”
»
SET > DV Set
Digital Monitor (Default: Auto)
Selects a receive mode when
is pushed in
the DV mode.
• Auto: Receives in the DV mode or the FM
mode, depending on the received
signal.
• Digital: Receives in the DV mode.
• Analog: Receives in the FM mode.
Digital Repeater Set (Default: ON)
Turns the Digital Repeater Set function ON or
OFF. When accessing a repeater that has a
call sign that is different than the transceiver’s
setting, this function reads the repeater’s
transmit signal and automatically sets the
repeater call sign.
• OFF: Turns OFF the function.
• ON: Automatically sets the repeater call
sign.
DV Auto Detect (Default: OFF)
Turns the DV mode Automatic Detect function
ON or OFF. When in the DV mode, if you receive
a non-digital signal, this function automatically
sets the operating mode to the FM mode.
• OFF: Turns the function OFF. The operating
mode is fixed to the DV mode.
• ON: Automatically selects the FM mode for
temporary operation.
RX Record (RPT) (Default: ALL)
The transceiver can record the data of up to
50 individual calls. When the received signal
includes a status message (“UR?” or “RPT?”)
that is sent back from the access repeater, you
can record up to 50 messages, or only the last
call, in the Received Call Record.
• ALL: Records up to 50 calls.
• Latest Only: Records only the last call.
BK (Default: OFF)
The Break-in (BK) function enables you to
break into a conversation, where the two other
stations are communicating with call sign
squelch enabled.
• OFF: Turns OFF the function.
• ON: Turns ON the function.
LThe BK function is automatically turned OFF when
the transceiver is turned OFF.