10-2
BASIC MANUAL
MAINTENANCE
10
10
Resetting
D
Partial reset
1. Open the RESET screen.
»
SET > Others > Reset
2. Touch “Partial Reset.”
3. Touch [YES].
LAfter resetting, the default VFO mode screen
is displayed.
DAll reset
1. Open the RESET screen.
»
SET > Others > Reset
2. Touch “All Reset.”
3. Touch [NEXT].
4. After carefully reading the displayed
message, touch [YES] to perform the All
reset.
LAfter resetting, the default VFO mode screen
is displayed.
When you cannot enter the Set mode
If a touch screen operation error or an
unexpected operation occurs, you cannot
enter the Set mode. In this case, perform an
All reset, as described below:
1. Turn OFF the transceiver.
2. While holding down
and , push
.
To Next Page
Loading...
