Icom IC-905 - D Setting the GPS Alarm Function to All Memories (All GPS Memories)

9
GPS OPERATION (ADVANCED)
9-25
GPS Alarm
D Setting the GPS Alarm function to All Memories (all GPS Memories)
1� Open the GPS ALARM screen.
»
GPS > GPS Alarm
2� Touch “Alarm Select.”
3� Touch “Group.”
4� Touch “All Memories.”
L If you want to set the alarm to a specic GPS
Memory group, touch “(No Group)” or “A” to “Z.”
5� To close the GPS ALARM screen, push
several times.
L Information
• When either one of the stations in the group enters the
set range, the alarm sounds 3 times.
• When the transceiver sounds a GPS Alarm, “GPS
ALARM” pops up on the screen, and “
” blinks. See the
illustration below.
• To cancel the GPS Alarm function, touch “OFF” in step 3
to the left.
“GPS ALARM” pops up on the screen
and the alarm sounds 3 times.
Blinks
TIP: When selecting “All Memories,” “No Group,” or
a GPS Memory group (A ~ Z) in step 4 to the left,
you also have to set “Alarm Area (Group)” to use the
GPS Alarm function.
»
GPS > GPS Alarm > Alarm Area (Group)