Icom IC-905 - Saving to Memory channels

10
D-STAR OPERATION (BASIC)
10-11
Saving to Memory channels
When “FROM” (Access repeater) and “TO”
(Destination) settings are saved to a Memory channel,
the settings can be selected by rotating in the
Memory mode�
Step 1. Saving settings into memory
1� On the DR screen, select the “FROM” and “TO”
settings to be saved into memory�
2� Push
�
3� Touch “Memory Write�”
4� Touch “Write to a New Channel�”
5� Touch the desired Memory channel�
(Example: channel 00 in group 00)
L To change a memory group, touch [GROUP]�
Touch to change
a memory group�
6� Touch [YES]�
• The operating data is entered in the selected
channel� “FROM” and “TO” names are automatically
entered as the Memory name�
(Up to 16 alphanumeric characters�)
Step 2. Viewing the saved contents
1� Hold down
for 1 second to cancel the DR
screen�
2� Select the Memory mode�
3� Rotate to select the saved channel�
(Example: channel 00 in group 00)
Memory name
TIP: Checking the Memory contents
You can check the Memory contents on the
MEMORY screen�
1� Open the MEMORY screen�
»
MEMORY
2� Touch a group that contains the Memory
channel you want to check� (Example: 00)