Icom IC-905 - D Troubleshooting for the Access Point Mode Operation

12
ABOUT THE DV GATEWAY FUNCTION
12-25
Troubleshooting
The following chart is designed to help you correct problems which are not equipment malfunctions�
If you are unable to locate the cause of a problem or solve it through the use of this chart, contact your Icom Dealer
or Service Center�
Problem Possible Cause Solution REF.
After your call, the repeater does
not return a status reply�
(No S-meter indication)
The wrong Access Point mode
transceiver is selected in the Remote
D-STAR transceiver�
Set “FROM” to the correct Access
Point mode transceiver�
–
The manually entered frequency or
duplex setting is wrong in the Remote
D-STAR transceiver�
Set the correct frequency or duplex
setting�
–
The transmission from the Remote
D-STAR transceiver did not reach the
Access Point mode transceiver�
Move to a place where the Remote
D-STAR transceiver can reach the
Access Point mode transceiver�
–
Transceiver connection is wrong� When using the Internal Gateway
function, check the connection
between the transceiver and the
router�
p� 12-11
When using the External Gateway
function, check the connection
between the transceiver and the
Windows or Android device�
pp� 12-13,
12-14
The Remote D-STAR transceiver’s call
sign has not been added to “Allowed
Call Sign List” in the transceiver,
RS-MS3W, or RS-MS3A, when
“Allowed Call Sign” is set to “Enable�”
When using the Internal Gateway
function, add the Remote D-STAR
transceiver’s call sign to “Allowed
Call Sign List” in the INTERNAL
GATEWAY SETTINGS screen�
p� 12-12
When using the External Gateway
function, add the Remote D-STAR
transceiver’s call sign to “Allowed
Call Sign List” in the RS-MS3W or
RS-MS3A�
RS-MS3W,
RS-MS3A’s
instruction
manual
When using the External Gateway
function, you did not click (touch)
<Start>
in the RS-MS3W or
RS-MS3A�
Click (touch) <Start>
in the
RS-MS3W or RS-MS3A�
After your call, the repeater
replies “UR?,” the Access Point
call sign and ID su󰀩x “G.”
The call was successfully sent to
the Access Point, but no station
immediately replied�
Wait for a while, and try again� –
D Troubleshooting for the Access Point mode operation