Icom IC-905 - GPS SET

9
GPS OPERATION (ADVANCED)
9-27
GPS SET
NOTE: The default settings shown below are for the USA transceiver version. The default settings may di󰀨er,
depending on your transceiver version. To return to your transceiver version’s default settings, push and
touch “Default.”
»
GPS > GPS Set
Position Input (Default: Internal GPS)
Selects how to capture position data.
• Internal GPS: Position data of the internal GPS
receiver is used for the GPS
functions.
• Manual: Manually enter the current Latitude,
Longitude, and Altitude in “Manual
Position.”
»
GPS > GPS Set > GPS Option
SBAS (Default: OFF)
Turns the SBAS (Satellite Based Augmentation
System) function ON or OFF.
L When turning ON this function, the GPS position
accuracy can be improved, but the transceiver’s power
consumption increases.
• OFF: Turns OFF the function.
• ON: Turns ON the function.
GLONASS (Default: OFF)
Selects whether or not to use the data from
the GLONASS (GLObal’naya NAvigatsionnaya
Sputnikovaya Sistema) satellites.
L When turning ON this function, the GPS position
accuracy can be improved, but the transceiver’s power
consumption increases.
• OFF: Does not use the data from the GLONASS
satellites.
• ON: Uses the data from the GLONASS satellites.
Satellite Information Out
(Default: GPS/QZSS/GLONASS)
Selects whether or not to output the data from the
QZSS (Quasi-Zenith Satellite System) satellites and
the GLONASS satellites.
• GPS/QZSS/GLONASS:
Outputs the data from the GPS
satellites, the QZSS satellites, and the
GLONASS satellites.
• GPS Only: Outputs the data from only the GPS
satellites.
»
GPS > GPS Set
Manual Position (Default: LATITUDE: 0°00.00′N,
LONGITUDE: 0°00.00′W,
ALTITUDE: ------ft)
Manually enter the latitude, longitude, and Altitude of
your current position.
L You can capture position data from the GPS receiver if
“Capture From GPS” is selected.
»
GPS
GPS TX Mode (Default: OFF)
Selects a GPS transmission mode to send GPS
position data while in the DV mode.
• OFF: Does not transmit GPS data.
• D-PRS: Transmits GPS data in the D-PRS format.
• NMEA: Transmits GPS data in the NMEA format.
»
GPS > GPS TX Mode > D-PRS
Unproto Address (Default: API905,DSTAR*)
Displays an unproto address of up to 56 alphanumeric
characters.
NOTE: You should use the default address, and
editing is not recommended.
TX Format (Default: Position)
Selects the format to transmit the position data in the
D-PRS mode.
• Position: The caller station is the mobile or base
station�
• Object: Transmits a certain location’s information,
such as an event, earthquake, and so on.
(The time stamp data is included.)
• Item: Transmits repeater or antenna information
that needs no time information�
(The time stamp data is not included.)
• Weather: Transmits weather information received
from a weather device.