Icom IC-905 - RECORDER SET screen

4
VOICE RECORDER FUNCTIONS
4-6
RECORDER SET screen
You can change the recorder settings on this screen�
1� Display the RECORDER SET screen�
»
RECORD > Recorder Set
2� Touch the item to set. (Example: TX REC Audio)
3� Touch the option to set. (Example: Monitor)
4� To close the RECORDER SET screen, push �
TIP: You can set each item to its default by touching
the item for 1 second, and then touching “Default” on
the QUICK MENU screen�
File Split (Default: ON)
Turns the File Split function ON or OFF�
• OFF: The audio is continuously recorded into the
le, even if you switch between transmit
and receive, or the squelch status changes
between open and closed�
When the recording le’s size becomes 2 GB,
the transceiver continues to record, but to a
new le.
• ON: While recording, if you switch between
transmit and receive, or the squelch status
changes between open and closed, a new le
is automatically created in the same folder,
and the audio is saved into the new one�
PTT Auto REC (Default: ON)
Turns the PTT Automatic Recording function ON or
OFF�
• OFF: The recording does not start, even when a
signal is transmitted.
• ON: The recording automatically starts when a
signal is transmitted.
The recording will stop when:
• 10 seconds has passed after the last transmission.
• 10 seconds has passed if no signal is received after
the last transmission.
- If you receive a signal within 10 seconds after
the last transmission, the received audio is also
recorded�
- If you receive another signal within 10 seconds
after the last reception, the received audio is also
recorded�
• 10 minutes has past while operating with the
squelch is open in the SSB, CW, RTTY, or AM
mode.
• The frequency or operating mode is changed.
PRE-REC for PTT Auto REC (Default: 10sec)
Selects whether or not to record the audio that is
received before the PTT Automatic Recording function
is activated�
• OFF: Does not record the audio.
• 5sec/10sec/15sec:
Records the audio that is previously received
in this set period of time.
TX REC Audio (Default: Direct)
Selects the transmit audio to record.
• Direct: Records the microphone audio.
• Monitor: Records the TX monitor audio.
RX REC Condition (Default: Squelch Auto)
Selects the recording setting for receive�
• Always: Records even if no signal is received.
• Squelch Auto: Records only when the squelch
opens�
( The recording will be paused when
the squelch closes while recording.)