Icom IC-905 - Troubleshooting

12
ABOUT THE DV GATEWAY FUNCTION
12-22
Troubleshooting
If an error icon is displayed when using the Internal Gateway function, read the following chart� If you are unable to
locate the cause of a problem or solve it through the use of this chart, contact your Icom Dealer or Service Center�
Icon Possible Cause Solution REF.
Transceiver connection is wrong� Check the connection between the
transceiver and the router�
p� 12-13
Gateway Repeater cannot be found� Check the Network settings� p� 12-7
The call sign has not been added
to “Allowed Call Sign List” in the
transceiver, when “Allowed Call Sign” is
set to “Enable�”
Set “Allowed Call Sign” to “Disable” in
the INTERNAL GATEWAY SETTINGS
screen�
p� 12-12
Add the Remote D-STAR transceiver’s
call sign to “Allowed Call Sign List” in
the INTERNAL GATEWAY SETTINGS
screen�
p� 12-12
Your call sign (MY) has not been
registered at a gateway server�
Register your call sign (MY) at a
gateway server�
p� 10-5
The Terminal/AP call sign that is set in
the transceiver has not been registered
in the RS-RP3C as the access point�
Register the Terminal/AP call sign
that is set in the transceiver in the
RS-RP3C as the access point�
p� 10-5
Destination station’s call sign (UR) has
not been registered to the gateway
server, or the call sign do not match
your transceiver’s setting�
Check the destination station’s
register information�
–
Destination station that uses the
Terminal mode or Access Point mode
does not transmit periodically�
Destination station makes a call� –
The repeater is busy� Wait for a while, and try again� –
A signal is received while transmitting� Destination station makes a call
again�
–
The transceiver cannot receive the
signal�
Destination station makes a call
again�
–
D Error icons of the transceiver