Icom IC-905 - D Linking to a Reflector

10
D-STAR OPERATION (BASIC)
10-13
About Reflectors
D Linking to a reflector
If your repeater is not currently linked to a reector, or
if you want to change it to another reector, follow the
steps below. Before linking to another reector, BE
SURE to unlink any current reector. (p. 10-12)
Direct inputting a Reector
1� Example: Directly entering “REF010BL�”
2� Touch “TO” to select, and then touch “TO” again�
3� Touch “Reflector�”
4� Touch “Link to Reflector�”
5� Touch “Direct Input�”
6� Touch [+] or [–] to select the reflector type,
reflector number, and module letter, then touch
[SET]�
• Returns to the DR screen, and “Link to Reector” and
entered reector is displayed in “TO.”
7� Hold down [PTT] to link to the reflector�
Direct inputting a Reector
TX History saves up to 5 reectors that your access
repeater linked to before�
Example: Select “REF010BL” in TX History�
1� Touch “TO” to select, and then touch “TO” again�
2� Touch “Reflector�”
3� Touch “Link to Reflector�”
4� Touch the reflector that you want to link to�
• Returns to the DR screen, and “Link to Reector” and
“REF010BL” are displayed in “TO�”
5� Hold down [PTT] to link to the reflector�