10
D-STAR OPERATION (BASIC)
10-4
Enter your call sign (MY) into the transceiver
To operate D-STAR, you must rst enter your call sign
into the MY call sign memory� You can enter up to 6
MY call signs�
NOTE:
• Your MY call sign must match the call sign registered on
a gateway repeater� (p� 10-5)
• The MY Call sign in the instructions is ONLY an
example that is used in explanations� You MUST enter
your own call sign, the one that was assigned to you
and is on your license�
Example: Enter “JA3YUA” as your own call sign into
“1�”
1� Open the MY CALL SIGN (DV) screen�
»
SET > My Station > My Call Sign (DV)
2� Touch the number for 1 second�
3� Touch “Edit�”
4� Enter your own call sign, then touch [ENT]�
5� Touch the entered call sign�
• Sets the call sign to be used as MY call sign�
6� To close the MY STATION screen, push
several times�
TIP: You can enter a note of up to 4 characters, such
as the model of the transceiver, name, area name,
after your call sign�
To Next Page
Loading...
