Icom IC-905 - Entering Scan Edges

7
SCANS
7-6
Entering Scan Edges
You can enter the upper and lower frequency edges
to the Program Scan Edge ranges for Program scans�
Each Program Scan Edge range has its own name,
mode, and IF lter settings.
You can enter a total of up to 25 Program Scan Edge
ranges�
L The default settings may di󰀨er, depending on the
transceiver version�
1� Display the SCAN SET screen�
»
SCAN > SET
2� Touch “Program Scan Edge�”
3� Touch the Scan Edge range that you want to
enter, for 1 second� (Example: 00)
4� Touch “Edit�”
5� Touch “NAME�”
6� Enter a name, then touch [ENT]�
7� Touch “FREQUENCY�”
8� Enter the upper and lower edge frequency, then
touch [ENT]�
Entry example: [1] [4] [4] [ENT] [1] [4] [6] [ENT]
L Touch to select the upper and lower edge
frequency, and then rotate
or touch the
keypad to edit the frequency�
9� Touch “MODE�”
10� Touch the mode to be used during a scan�
(Example: FM)
L When you select “---,” the mode set in the VFO mode
is used during a scan�
L When you select “DD,” you cannot select “FIL�”
11� Touch “FIL�”
12� Touch the IF filter number to be used during a
scan� (Example: FIL 1)
13� Touch “<<Write>>�”
14� Touch [YES]�
• A beep sounds, and the Program Scan Edge range is
entered�
• Returns to the PROGRAM SCAN EDGE screen�