12
ABOUT THE DV GATEWAY FUNCTION
12-17
Access Point mode operation
In this section, set an Access Point transceiver�
1� Open the DV GATEWAY screen�
»
2 > DV GW
2�
T
ouc
h “<
<Acc
ess Point Mode>>
�
”
3� Rotate
to set the operating frequency�
L The frequency is used to communicate with the
Remote D-STAR transceiver�
L In the Access Point mode, you can change the
operating frequency�
Internal Gateway icon
“Ext” is displayed when using the
External Gateway function�
NOTE: BE SURE to check your local regulations or
laws to select the appropriate operating frequency�
When using the External Gateway function
After the transceiver is in the Access Point mode, click
(touch) <Start>
in the RS-MS3W or RS-MS3A�
L If an error message is displayed, see page 12-27 for tips
on how to solve the problem�
NOTE: In the Access Point mode
• The Power Save function is not activated�
• The following items are automatically set�
Mode: VFO mode*
Operating mode: DV mode*
Duplex mode: OFF*
AFC function: OFF
RIT function: OFF
VOX function: OFF
MONITOR function: OFF
* These settings do not return to the previous settings,
even if you cancel the Access Point mode�
• The Access Point mode is not automatically canceled,
even if you turn OFF the transceiver, then turn it ON
again�
TIP: Canceling the Access Point mode
Touch “<<Normal Mode>>” in the QUICK MENU
screen or the DV GATEWAY screen�
»
2 > DV GW > <<Normal Mode>>
L To display the QUICK MENU screen, push �
L When using the External Gateway function, click (touch)
<Stop>
in the RS-MS3W or RS-MS3A before the
transceiver returns to the normal mode�
About the Internal Gateway icon
When using the Internal Gateway function, displays
the communication status�
Icon Status
In the standby mode
While transmitting
While receiving
Transmission error (The repeater is busy�)
Transmission error
Network error
Receiving while transmitting
Receive error
L If an error icon is displayed, see page 12-22 for tips on
how to solve the problem�
D Setting the Access Point mode
To Next Page
Loading...
