Icom IC-905 - SCAN SET screen

7
SCANS
7-4
SCAN SET screen
You can change the recorder settings on this screen�
1� Display the SCAN screen�
»
SCAN
2� Touch [SET]�
3� Touch the item to set� (Example: SCAN Speed)
4� Touch the option to set� (Example: Slow)
5� To close the SCAN SET screen, push �
TIP: You can set each item to its default by touching
the item for 1 second, and then touching “Default” on
the QUICK MENU screen�
SCAN Speed (Default: Fast)
Sets the desired scan speed to slow or fast�
• Slow: Scan speed is slow�
• Fast: Scan speed is fast�
SCAN Resume (Default: ON)
Sets the Scan Resume function to ON or OFF�
• OFF: When a signal is detected, cancels the scan�
• ON: When a signal is detected, the scan pauses
for 10 seconds, then resumes�
Two seconds after the signal disappears, the
scan resumes�
Pause Timer (Default: 10sec)
When Scan Resume is ON, selects the Scan Pause
Timer� When a signal is received, the scan pauses for
this set period of time�
• 2 ~ 20sec: When a signal is received, the scan
pauses for 2 ~ 20 seconds (in 2 second
steps)�
• HOLD: The scan pauses until the signal
disappears�
Resume Timer (Default: 2sec)
Selects the scan Resume Timer� When a received
signal disappears, the scan resumes after this set
period of time passed�
• 0sec: The scan resumes immediately after the
signal disappears�
• 1 ~ 5sec: The scan resumes 1 ~ 5 seconds after
the signal disappears�
• HOLD: The scan remains paused for the
Pause Timer setting, even if the signal
disappears�
Temporary Skip Timer (Default: 5min)
Selects the e󰀨ective time of the Temporary Skip
function�
L This timer is activated for the VFO scan, Memory scan,
and DR scan�
• 5min/10min/15min:
The Temporary Skip channels are
skipped for the set period of time�
• While Scanning:
The Temporary Skip channels are
skipped until the scan is stopped�
• While Powered ON:
The Temporary Skip channels are skipped
until the transceiver is turned OFF�
MAIN DIAL Operation (SCAN) (Default: Up/Down)
Selects the function of while scanning�
• OFF: Rotating stops the scan�
• Up/Down: Rotating changes the scanning direction�
Program Scan Edge
You can delete, copy, or edit the lower and higher
frequencies for programmed scans�
The transceiver has a total of up to 25 frequency
ranges (00 ~ 24), and you can set the scan name,
mode, and the IF lter for each Scan Edge.
L The default setting may di󰀨er, depending on the
transceiver version�
L See page 7-6 for entering Scan Edges�