Icom IC-905 - D Mode Select Scan Operation; D ∂F Scan Operation; F Scan and Fine ∂F Scan; Mode Select Scan

7
SCANS
7-9
Mode Select scan
Repeatedly scans Memory channels (except C1 and
C2) that are set to the mode selected before starting
the scan�
Only Memory channels set to
the FM mode are scanned�
Ch 99
FM
Ch 00
FM
Ch 01
AM
Ch 02
FM
Ch 03
FM
Ch 04
FM
Ch 05
FM
Ch 06
AM
Ch 50
DV
Ch 98
FM
D Mode Select scan operation
1� Select the Memory mode�
2� Set the operating mode�
3� Display the SCAN screen�
»
SCAN
4� Touch [MEMO] for 1 second�
5� Touch “MODE SELECT SCAN�”
• The Mode Select scan starts�
L When a signal is detected, the scan pauses
according to the “SCAN Resume” setting, and then
resumes�
L To cancel the scan, touch [MEMO]�
6� To close the SCAN screen, push �
Blinks
∂F scan and Fine ∂F scan
Repeatedly scans within the ∂F span area� The scan
starts from the center frequency�
Scan edge Scan edge
Scan Scan
Jump
Start
Center
146�18 MHz 146�19 MHz146�17 MHz
(Example: Span: ±10 kHz)
L In a Fine scan (Programmed or ∂F), the scan speed
decreases when the squelch opens, but the transceiver
keeps scanning� The scan tuning step changes to 10 Hz
when the squelch opens�
D ∂F scan operation
1� Set the center frequency�
2� Set the operating mode and tuning step�
(Example: FM, 1 kHz)
L You can also change these settings while scanning�
3� Display the SCAN screen�
»
SCAN
4� Touch [∂F SPAN] several times to select the span�
• Each touch changes the span�
5� Touch [∂F]�
• The ∂F scan starts�
L When a signal is detected, the scan pauses according
to the “SCAN Resume” setting, and then resumes�
L To turn the TS function to scan by the frequency step
setting, touch the 100 kHz digit on the frequency readout�
L To cancel the scan, touch [∂F] again�
6� To switch to the Fine ∂F scan, touch [FINE]�
Blinks
• The scan frequency step changes to 50 Hz�
L To return to the ∂F scan, touch [FINE] again�
7� To close the SCAN screen, push �
Blinks