Icom IC-905 - Programmed scan and Fine Programmed scan

7
SCANS
7-5
Programmed scan and Fine Programmed scan
Repeatedly scans the Program Scan Edge ranges�
Lower
frequency
Higher
frequency
Scan
Jump
L To change the upper and lower frequency, see page
7-6 for details�
L If the same frequencies are entered into the upper and
lower frequency, the Programmed scan does not start�
L The Fine Programmed scan is most e󰀨ective in the
SSB, CW, and RTTY modes�
D Programmed scan operation
1� Select the VFO mode�
2� Select the operating mode and tuning step�
(Example: USB, 1 kHz)
3� Display the SCAN screen�
»
SCAN
4� Touch [PROG] for 1 second�
5� Touch the frequency range to scan�
(Example: P00)
• The Programmed scan starts�
L When a signal is detected, the scan pauses
according to the “SCAN Resume” setting, and then
resumes�
L You can change the tuning step by touching kHz�
L To cancel the scan, touch [PROG]�
6� To switch to the Fine Programmed scan, touch
[FINE]�
• The tuning step changes to 50 Hz steps�
L When a signal is detected, the tuning step changes to
10 Hz steps�
L To return to the Programmed scan, touch [FINE]
again�
7� To close the SCAN screen, push �
Blinks
Blinks
Blinks