Icom IC-905 - Page 195

12
ABOUT THE DV GATEWAY FUNCTION
12-26
Troubleshooting
D Troubleshooting for the Access Point mode operation
Problem Possible Cause Solution REF.
After your call, the repeater
replies “RX” or “RPT?” and the
Access Point call sign and ID
su󰀩x “G.”
The Remote D-STAR transceiver’s call
sign has not been set in the transceiver�
Set the Remote transceiver’s call sign
in the transceiver�
p� 10-4
The Remote D-STAR transceiver’s
call sign has not been registered at a
gateway server�
Register the Remote D-STAR
transceiver’s call sign at a gateway
server�
p� 10-5
The Terminal/AP call sign that is
set in the transceiver, RS-MS3A, or
RS-MS3W has not been registered in
the RS-RP3C as the access point�
When using the Internal Gateway
function, register the Terminal/AP call
sign that is set in the transceiver into
the RS-RP3C as the access point�
p� 10-5
When using the External Gateway
function, register the Terminal/AP call
sign that is set in the RS-MS3A or
RS-MS3W into the RS-RP3C as the
access point�
p� 10-5
The destination station’s call sign (UR)
has not been registered to the gateway
server, or the registered contents do
not match your transceiver’s setting�
Check the destination station’s
register information�
–
A wrong destination repeater’s call sign
is set to “TO�”
Set “TO” to the correct destination
repeater’s call sign�
p� 12-18
The transceiver’s Internal Gateway
settings or the application software
settings are wrong�
When using the Internal Gateway
function, correctly set the transceiver’s
Internal Gateway settings�
p� 12-11
When using the External Gateway
function, correctly set the RS-MS3W
or the RS-MS3A�
RS-MS3W,
RS-MS3A’s
instruction
manual
The destination station that uses the
Terminal mode or Access Point mode
does not transmit periodically�
The destination station makes a call
again�
–
After your call, the repeater
replies ’RPT?’ and the access
repeater’s call sign�
The repeater cannot connect to the
destination repeater�
Wait for a while, and try again� –
The repeater is busy�
“L” appears on the LCD� While receiving through the Internet,
some packets may be lost due to
network error (poor data throughput
performance)�
Wait for a while, and try again�
L When the transceiver receives
corrupted data, and misidenties it
is as Packet Loss, “L” is displayed�
–
“DV” and “FM” icons alternately
blink�
While in the DV mode, an FM signal is
received�
Use a di󰀨erent operating frequency
until there are no FM signals on the
original frequency�
–
You can transmit, but cannot
receive from the destination
repeater�
You cannot connect to the Internet, or
Global IP address is not assigned�
Check the Internet connection and
Global IP address assignment�
p� 12-5
The router or mobile router’s port is not
correctly forwarded�
Forward the router or mobile router’s
correct port to your device�
p� 12-5
The rewall is blocking the necessary
port�
Check your rewall settings. p� 12-13